View unanswered posts | View active topics


Board index » Public Boiler & Pressure Vessel Forum » ASME Code Section V - NDE

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Previous topic | Next topic 
Author Message
mikeqc1
 Post subject: Wall thickness
PostPosted: Tue Mar 09, 2010 5:08 pm 
Offline
----------------
----------------

Joined: Fri May 02, 2008 8:45 pm
Posts: 93
Gentlemen, if i purchased a pipe and required a MIN wall Of .322 on the Purchase order, and during fit up and welding i find that approx 1/8 of the thickness of this factory seam is unfused along the whole length, could this be rejected for exceeding min wall thickness requirment?
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Public Boiler & Pressure Vessel Forum » ASME Code Section V - NDE

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO