View unanswered posts | View active topics


Board index » Public Boiler & Pressure Vessel Forum » ASME Code Section VIII, Divison 1 - Pressure Vessels

All times are UTC + 2 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
deep79pk
PostPosted: Mon Jan 24, 2011 12:49 pm 
Offline
----------------
----------------

Joined: Fri Nov 06, 2009 5:43 am
Posts: 14
Location: Islamabad ,Pakistan
Dears,
Hello,
Sir,Is welding allowed in Tie Rod of Heat Exchanger?In case of any vibration,How can ensure the strength of weld in the Tie Rod?RT is enough for this porpose?In case of Corrosive service,what can I do??
Please Reply,It is urgent
Thanks a lot
Deep

_________________
Deep
Top
 Profile  
 
Javed Nasir
PostPosted: Mon Jan 24, 2011 1:53 pm 
Offline
----------------
----------------

Joined: Tue Dec 01, 2009 1:55 pm
Posts: 270
Location: DESCON Engineering Limited, Pakistan
Deep,

We use full penetration weld in stay rods in boiler construction, stay rods exactly serve the same purpose as tie rods do.
RT is not required, UT is sufficient.
Grind flush the weld to represent a smooth face for a nice assembly.

_________________
Thanks & Regards,
Nasir
Welding Engineer
DESCON Engineering Limited.
Lahore, Pakistan.
Mobile # 0092-336-4145402
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Public Boiler & Pressure Vessel Forum » ASME Code Section VIII, Divison 1 - Pressure Vessels

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group

phpBB SEO